Home > XTREME > Motor Science




  • PROPER SUPPORT COMPONENTS

  • NO EXAGGERATED HORSEPOWER

  • TUNING FOR ALL ENVIRONMENTS

  • CA EMISSIONS CERTIFIED

  • BREAK IN PROCEDURES



A proud sponsor of






HORSEPOWER

All engines are rated using calibrated, scientific measurement devices. We do not estimate or exaggerate horsepower or torque numbers, enabling proper choice of drive train and engine support components.

What is a Horsepower?

1 horsepower = 1 foot pound of torque @ 5252 rpm

Fuel Required

For every 100 hp on a turbo engine you need 820cc/min of gasoline assuming a B.S.F.C. of .625 a fuel pressure 43.5 PSI greater than manifold pressure and a 80% duty cycle. Therefore a 400 HP 4cyl turbo engine requires one 3280cc/min or four 820cc/min injectors.

MACHINE SHOP

We have a full, in-house machine shop and engine development facility.



TUNING

We have over 450 hours of dyno time invested in each of our turnkey engine packages to ensure peak performance and reliability in all environments.

All engine tuning and reliability testing is performed on a 1600 hp engine dyno capable of stressing the engine harder than the vehicle that it will be installed in, allowing us to properly test and tune each engine in its full range of RPM and throttle position.



EMISSIONS

Metric Motors has engines available that will meet California OHV emission requirements and is working with the state of California to get all of our engines California certified.


TURN KEY ENGINES

All Turn Key engines go through Metric Motors break-in and test procedures on our dyno. This allows us to test the package as a whole, i.e., fuel pump, injectors, turbo, all gaskets and seals, tuning, ignition system, emissions, sensors, charging system, etc.